mgtm98/pcie5_phy issues and pull requests

#79 - helper_macros.svh issue

Issue - State: open - Opened by jc70100322 over 2 years ago

#78 - get_width issue

Issue - State: open - Opened by jc70100322 over 2 years ago

#77 - stuck in Recovery.config substate during speed change (Design is down stream)

Issue - State: open - Opened by ibrahemkhafaga over 3 years ago
Labels: Design Issue

#76 - TS ID is inconsistent in TS2

Issue - State: open - Opened by ibrahemkhafaga over 3 years ago
Labels: Design Issue

#75 - The lp_tlp_start and lp_dllp_start signals are asserted at the same time

Issue - State: closed - Opened by mennnatullah over 3 years ago
Labels: Verification Issue

#74 - DUT stuck in Configuration Idle

Issue - State: open - Opened by LobnaTarek over 3 years ago - 1 comment
Labels: Design Issue

#73 - Assigning a "reg" type variable using continuous assignment

Issue - State: closed - Opened by ibrahemkhafaga over 3 years ago
Labels: Design Issue, Fixed and awaits validation

#72 - Can't detect IDLE data when ENV is in config.idle

Issue - State: closed - Opened by mennnatullah over 3 years ago
Labels: Design Issue, Fixed and awaits validation

#71 - ENV is not detecting IDLE data

Issue - State: closed - Opened by mennnatullah over 3 years ago
Labels: Verification Issue

#70 - DUT is sending DLLP through LPIF while ENV is sending IDLE data through PIPE in Configuration.Idle substate

Issue - State: closed - Opened by mennnatullah over 3 years ago - 4 comments
Labels: Design Issue, Fixed and awaits validation

#69 - DUT sending wrong data when it stops sending TSes and start sending idle data

Issue - State: closed - Opened by mennnatullah over 3 years ago - 6 comments
Labels: Design Issue, Fixed and awaits validation

#68 - The idle data sent from DUT at Configuration.Idle are not scrambled

Issue - State: closed - Opened by MohamedAli25 over 3 years ago - 2 comments
Labels: Design Issue

#67 - Doesn't send idle data in Configuration.Idle

Issue - State: closed - Opened by MohamedAli25 over 3 years ago
Labels: Verification Issue

#66 - "RxStandby" signal is missing

Issue - State: closed - Opened by ibrahemkhafaga over 3 years ago
Labels: Design Issue, Fixed and awaits validation

#65 - signal width

Issue - State: closed - Opened by ibrahemkhafaga over 3 years ago - 1 comment
Labels: Design Issue

#64 - DUT_start_polling_e event is triggered before the pipe_linkup_seq waits for it

Issue - State: closed - Opened by MohamedAli25 over 3 years ago - 1 comment
Labels: Verification Issue

#63 - stuck in config linkwidth start (environment is downstream/DUT is upstream)

Issue - State: closed - Opened by mennnatullah over 3 years ago - 1 comment
Labels: Design Issue

#62 - stuck in config lanenum wait (environment is upstream/DUT is downstream)

Issue - State: closed - Opened by mennnatullah over 3 years ago - 1 comment
Labels: Verification Issue

#61 - TxElecIdle should be de-asserted at the same clock cycle the first TS in the Polling state starts to be transmitted

Issue - State: open - Opened by MohamedAli25 over 3 years ago - 3 comments
Labels: Design Issue

#60 - stuck in configuration state

Issue - State: closed - Opened by MohamedAli25 over 3 years ago
Labels: Verification Issue

#59 - Compilation error in the design code (TxLtssm.v file)

Issue - State: closed - Opened by MohamedAli25 over 3 years ago - 1 comment
Labels: Design Issue

#58 - bug in task send_tses

Issue - State: closed - Opened by MohamedAli25 over 3 years ago - 1 comment
Labels: Verification Issue

#57 - stuck in polling.active

Issue - State: closed - Opened by mennnatullah over 3 years ago
Labels: Verification Issue

#56 - COM character is sent on 2 clock cycles in the TS instead on only 1 clock cycle

Issue - State: closed - Opened by MohamedAli25 over 3 years ago - 2 comments
Labels: Design Issue

#55 - bug in task received_tses

Issue - State: closed - Opened by MohamedAli25 over 3 years ago
Labels: Verification Issue

#54 - The PhyStatus keeps toggling in the Polling State

Issue - State: closed - Opened by MohamedAli25 over 3 years ago
Labels: Verification Issue

#53 - Fix the send_ts/send_tses tasks in pipe_driver_bfm

Issue - State: closed - Opened by MohamedAli25 over 3 years ago
Labels: Verification Issue

#52 - powerdown doesn't change to P0 after receiver detection to enter polling state

Issue - State: closed - Opened by NadaTarek-1 over 3 years ago - 2 comments
Labels: Design Issue

#51 - why TxDetectRxLoopback is asserted again after deassertion (after receiver detection)

Issue - State: closed - Opened by NadaTarek-1 over 3 years ago - 1 comment
Labels: Design Issue

#50 - Add the default values for the reset scenario

Issue - State: closed - Opened by MohamedAli25 over 3 years ago
Labels: Verification Issue

#49 - TxElecidle is not asserted during Reset

Issue - State: closed - Opened by NadaTarek-1 over 3 years ago
Labels: Design Issue

#48 - powerdown is not in p1 during reset and detect state

Issue - State: closed - Opened by NadaTarek-1 over 3 years ago - 2 comments
Labels: Design Issue

#47 - reset value in lpif in reset in driver bfm is re-set to "0000"

Issue - State: closed - Opened by mennnatullah over 3 years ago

#46 - The TxDetectRxLoopback signal is not asserted in detect state

Issue - State: closed - Opened by mas1998m over 3 years ago - 4 comments
Labels: Design Issue

#45 - the PhyStatus signal isn't de-asserted at the reset scenario in PIPE

Issue - State: closed - Opened by MohamedAli25 over 3 years ago

#44 - Default signals values in pipe after reset

Issue - State: closed - Opened by mennnatullah over 3 years ago

#43 - TxDetectRx signal can't be detected to be 1 to start detect scenario

Issue - State: closed - Opened by mennnatullah over 3 years ago
Labels: Design Issue

#42 - Tasks

Issue - State: closed - Opened by MohamedAli25 over 3 years ago

#41 - 18/5/2021 Tasks

Issue - State: closed - Opened by MohamedAli25 over 3 years ago

#40 - check polling_state tasks code

Issue - State: closed - Opened by MohamedAli25 over 3 years ago

#39 - implement send_tses task inside pipe_driver_bfm

Issue - State: closed - Opened by MohamedAli25 over 3 years ago

#38 - Mismatch between signals from design team and Specifications

Issue - State: closed - Opened by mgtm98 over 3 years ago
Labels: Design

#37 - My Changes

Pull Request - State: closed - Opened by MohamedAli25 over 3 years ago

#36 - Tasks 27/4/2021

Issue - State: closed - Opened by MohamedAli25 over 3 years ago - 1 comment

#35 - remove link_up.svh file in the tb directory if you don't need it

Issue - State: closed - Opened by MohamedAli25 over 3 years ago

#34 - If there is no need for the ts.svh file, remove it

Issue - State: closed - Opened by MohamedAli25 over 3 years ago - 1 comment

#33 - change signals names to the new names

Issue - State: closed - Opened by MohamedAli25 over 3 years ago - 1 comment

#32 - move configuration state from pipe_driver_bfm to pipe_link_up_seq

Issue - State: closed - Opened by MohamedAli25 over 3 years ago

#31 - move polling state from pipe_driver_bfm to pipe_link_up_seq

Issue - State: closed - Opened by MohamedAli25 over 3 years ago

#30 - There are two tasks that are called receive_ts in pipe_monitor_bfm so which one should remain?

Issue - State: closed - Opened by MohamedAli25 over 3 years ago

#29 - Add comments for the blocks you added in the pipe_driver_bfm about their purpose

Issue - State: closed - Opened by MohamedAli25 over 3 years ago

#28 - Finish lpif_monitor_bfm link up block

Issue - State: closed - Opened by MohamedAli25 over 3 years ago

#27 - Remove the include of common_pkg and replace it by compiling the common_pkg before the desired one to be compiled

Issue - State: closed - Opened by MohamedAli25 over 3 years ago

#26 - 14/4/2020 Tasks

Issue - State: closed - Opened by MohamedAli25 over 3 years ago

#25 - Do we need the BFM interfaces to be synthesizable

Issue - State: closed - Opened by mgtm98 over 3 years ago
Labels: question

#24 - use speed_mode_t or use gen_t not both

Issue - State: closed - Opened by mgtm98 over 3 years ago
Labels: duplicate

#23 - Remove common_pkg.svh to lpif_types.svh and pipe_types.svh

Issue - State: closed - Opened by mgtm98 over 3 years ago

#22 - Questions

Issue - State: closed - Opened by mgtm98 over 3 years ago
Labels: question

#21 - Creating a new pull request for initial environment code review

Pull Request - State: closed - Opened by usfkotb almost 4 years ago

#18 - pcie_test_pkg

Issue - State: closed - Opened by MohamedAli25 almost 4 years ago - 1 comment
Labels: Confirm

#17 - pcie_test

Issue - State: closed - Opened by MohamedAli25 almost 4 years ago - 4 comments
Labels: Confirm

#16 - The new Building mechanism

Issue - State: closed - Opened by mgtm98 almost 4 years ago - 2 comments
Labels: question

#15 - pipe_monitor

Issue - State: closed - Opened by MohamedAli25 almost 4 years ago - 3 comments

#14 - pipe_driver

Issue - State: closed - Opened by MohamedAli25 almost 4 years ago

#13 - pipe interfaces should be parameterized

Issue - State: closed - Opened by MohamedAli25 almost 4 years ago - 1 comment
Labels: enhancement

#12 - pipe_coverage_monitor

Issue - State: closed - Opened by MohamedAli25 almost 4 years ago

#11 - pipe_agent

Issue - State: closed - Opened by MohamedAli25 almost 4 years ago - 1 comment
Labels: bug, enhancement, Confirm

#10 - pipe_agent_pkg

Issue - State: closed - Opened by MohamedAli25 almost 4 years ago - 4 comments
Labels: Confirm

#9 - common_pkg

Issue - State: closed - Opened by MohamedAli25 almost 4 years ago - 5 comments
Labels: question, Confirm

#8 - lpif_coverage_monitor

Issue - State: closed - Opened by MohamedAli25 almost 4 years ago

#7 - lpif_monitor

Issue - State: closed - Opened by MohamedAli25 almost 4 years ago - 1 comment

#6 - lpif interfaces should be parametrized

Issue - State: closed - Opened by MohamedAli25 almost 4 years ago

#5 - lpif_driver_bfm

Issue - State: closed - Opened by MohamedAli25 almost 4 years ago - 1 comment

#4 - lpif_agent

Issue - State: closed - Opened by MohamedAli25 almost 4 years ago - 1 comment
Labels: bug, Confirm

#3 - Tasks 2/2/2021

Issue - State: closed - Opened by MohamedAli25 almost 4 years ago

#2 - Finish the lpif_monitor notify methods

Issue - State: closed - Opened by MohamedAli25 almost 4 years ago - 1 comment

#1 - Problem with lpif_agent modify build_phase

Issue - State: closed - Opened by MohamedAli25 almost 4 years ago - 1 comment

GitHub / mgtm98/pcie5_phy issues and pull requests