Ecosyste.ms: Issues
An open API service for providing issue and pull request metadata for open source projects.
GitHub / gauteh/sfy issues and pull requests
#177 - web.post: update blues-notecard
Pull Request -
State: closed - Opened by gauteh 3 months ago
#176 - serialize output for velocity components and accuracy estimate
Pull Request -
State: closed - Opened by edwinrainville 3 months ago
#175 - Set up configuration settings for PPP-RTK receiver and sets up json output from send data to sfy
Pull Request -
State: closed - Opened by edwinrainville 4 months ago
- 1 comment
#174 - Real-time transmission of data
Issue -
State: closed - Opened by gauteh 4 months ago
#173 - SFY variant with external UBLOX GPS
Pull Request -
State: closed - Opened by gauteh 4 months ago
- 3 comments
#172 - Upgrade all drivers and firmware to use embedded-hal
Issue -
State: open - Opened by gauteh 5 months ago
#171 - imu i2c: 100 & 400 kHz
Pull Request -
State: closed - Opened by gauteh 5 months ago
#170 - RTK+PPP
Issue -
State: open - Opened by gauteh 5 months ago
- 26 comments
Labels: hardware
#169 - Notecarrier B v3.1: causes interference with IMU I2C at 1MHz
Issue -
State: open - Opened by gauteh 5 months ago
Labels: hardware
#168 - Could you add SD card to hardware V3?
Issue -
State: closed - Opened by Arakistech 8 months ago
#167 - Could you add a SD card to Hardware V2?
Issue -
State: closed - Opened by Arakistech 8 months ago
- 1 comment
#166 - Notecard env commands
Issue -
State: open - Opened by gauteh 9 months ago
Labels: documentation, hardware, modem
#165 - PCB v3
Issue -
State: open - Opened by gauteh 10 months ago
- 3 comments
Labels: hardware
#164 - Set up, configure and read temp probes
Pull Request -
State: open - Opened by gauteh 11 months ago
- 2 comments
#163 - PCB v2.0
Issue -
State: closed - Opened by gauteh 12 months ago
- 4 comments
#162 - data: update to new sqlx and other deps
Pull Request -
State: open - Opened by gauteh 12 months ago
#161 - SimdFloat -> num::SimdFloat
Pull Request -
State: closed - Opened by gauteh about 1 year ago
#160 - use telenor martime sim
Pull Request -
State: closed - Opened by gauteh about 1 year ago
#159 - sd: increase collection size to 1k
Pull Request -
State: closed - Opened by gauteh about 1 year ago
#158 - wip: create dirs
Pull Request -
State: open - Opened by gauteh about 1 year ago
#157 - sfy: bump sdmmc to 0.6.0 and remove old 'handles' code (now part of sdmmc)
Pull Request -
State: closed - Opened by gauteh about 1 year ago
#156 - SD-storage: use separate dirs to avoid slow linear walk
Issue -
State: open - Opened by gauteh about 1 year ago
#155 - send raw IMU data
Issue -
State: open - Opened by gauteh about 1 year ago
#154 - low-pass filter signal: to avoid range saturation
Issue -
State: open - Opened by gauteh about 1 year ago
#153 - Use rust-fatfs for SD-card
Issue -
State: open - Opened by gauteh over 1 year ago
#152 - surf
Pull Request -
State: closed - Opened by gauteh over 1 year ago
#151 - Increase DPS range to 2000
Issue -
State: closed - Opened by gauteh over 1 year ago
- 1 comment
#150 - Swap to binary-protocol for communication with modem
Issue -
State: open - Opened by gauteh over 1 year ago
#149 - reduce loop delays, process all data immediately.
Pull Request -
State: closed - Opened by gauteh over 1 year ago
#148 - pointing driver to new fork
Pull Request -
State: open - Opened by stianvikanes over 1 year ago
#147 - Adding test suggestion
Pull Request -
State: open - Opened by stianvikanes over 1 year ago
- 1 comment
#146 - put fir as default
Pull Request -
State: closed - Opened by stianvikanes over 1 year ago
- 1 comment
#145 - the `fir` feature should be enabled by default
Issue -
State: closed - Opened by gauteh over 1 year ago
#144 - Serialization of temperature from IMU is possibly always skipped
Issue -
State: open - Opened by gauteh over 1 year ago
- 1 comment
#143 - MODE_0
Pull Request -
State: closed - Opened by stianvikanes over 1 year ago
- 1 comment
#142 - Tuning the frequencies
Pull Request -
State: open - Opened by stianvikanes over 1 year ago
- 15 comments
#141 - Use GPS to get low-frequency directional spectrum
Issue -
State: open - Opened by gauteh over 1 year ago
#140 - Use GPS and IMU to get directional spectrum
Issue -
State: open - Opened by gauteh over 1 year ago
#139 - Fuse GPS and IMU to get accurate position
Issue -
State: open - Opened by gauteh over 1 year ago
- 9 comments
#138 - Blink led to indicate startup
Pull Request -
State: closed - Opened by stianvikanes over 1 year ago
#137 - sfy-data: analysis endpoints for hm0, trajectory and netcdf-files
Issue -
State: open - Opened by gauteh over 1 year ago
#136 - solar panel batteries
Issue -
State: open - Opened by gauteh over 1 year ago
#135 - Read and send real IMU frequency from IMU register
Issue -
State: open - Opened by gauteh over 1 year ago
#134 - Run IMU and Kalman-filter at atleast 2000 Hz
Issue -
State: open - Opened by gauteh over 1 year ago
#133 - Blink blue LED to indicate start-up
Issue -
State: closed - Opened by gauteh over 1 year ago
#132 - Add link for Torunn's M.Sc
Issue -
State: closed - Opened by gauteh over 1 year ago
#131 - Opt storage 208hz
Pull Request -
State: closed - Opened by gauteh over 1 year ago
#130 - Optional storage and power saving
Pull Request -
State: closed - Opened by gauteh over 1 year ago
#129 - Artemis will sometimes use more than 50 mA
Issue -
State: closed - Opened by gauteh over 1 year ago
- 1 comment
Labels: bug
#128 - Resources for getting started with embedded rust development of the SFY or similar
Issue -
State: open - Opened by gauteh over 1 year ago
#127 - power drain, main loop: do not check location every iteration
Issue -
State: closed - Opened by gauteh over 1 year ago
Labels: rust, student-project, power
#126 - maximum g in breakers: at least 8g
Issue -
State: closed - Opened by gauteh over 1 year ago
- 1 comment
#125 - Observed frequency is 48.57 Hz rather than 52 Hz (IMU datasheet)
Issue -
State: closed - Opened by gauteh over 1 year ago
- 6 comments
#124 - Reduce power use
Issue -
State: closed - Opened by gauteh almost 2 years ago
- 4 comments
Labels: student-project
#123 - solar panel
Issue -
State: open - Opened by jerabaul29 almost 2 years ago
- 11 comments
Labels: student-project
#122 - Added switch skip_imu to sfydata collection archive. Also fixed bug w…
Pull Request -
State: closed - Opened by knutfrode almost 2 years ago
#121 - waves: IMU sample 208 Hz
Pull Request -
State: closed - Opened by gauteh almost 2 years ago
#120 - sfydata imu condense
Pull Request -
State: closed - Opened by gauteh almost 2 years ago
#119 - Dev
Pull Request -
State: closed - Opened by knutfrode almost 2 years ago
#118 - move sfy-data to kubernetes (or something)
Issue -
State: closed - Opened by gauteh almost 2 years ago
- 5 comments
#117 - couple of points for next discussion: i) burst mode, ii) flash as "EEPROM"
Issue -
State: closed - Opened by jerabaul29 almost 2 years ago
#116 - make it clear there is a PCB available that can be ordered with SD card slot pre soldered etc
Issue -
State: open - Opened by jerabaul29 almost 2 years ago
- 1 comment
Labels: documentation
#115 - Overflow in sd-mmc library
Issue -
State: closed - Opened by gauteh almost 2 years ago
- 2 comments
Labels: bug
#114 - postgres
Pull Request -
State: open - Opened by gauteh almost 2 years ago
#113 - wire: start serializing as u16
Pull Request -
State: closed - Opened by gauteh about 2 years ago
- 2 comments
#112 - use a VN100 as a "reasonable well implemented data fusion benchmark" to get a typical comparison point?
Issue -
State: closed - Opened by jerabaul29 about 2 years ago
#111 - tuning noise levels to the exact chip, tuning for bias of the gyro by removing offset
Issue -
State: open - Opened by jerabaul29 about 2 years ago
#110 - test bench
Issue -
State: open - Opened by jerabaul29 about 2 years ago
#109 - synthetic data and notebook
Issue -
State: open - Opened by jerabaul29 about 2 years ago
- 1 comment
#108 - Kalman + quaternion processing
Issue -
State: open - Opened by jerabaul29 about 2 years ago
#107 - sneaky sources of problems with 6dof / Kalman filter etc
Issue -
State: open - Opened by jerabaul29 about 2 years ago
- 1 comment
#106 - transmit data as uint16's + min/max f32s
Issue -
State: closed - Opened by gauteh about 2 years ago
- 1 comment
#105 - Keys of trajectory_dict_to_dataset are now drifter names. Also handli…
Pull Request -
State: closed - Opened by knutfrode about 2 years ago
#104 - sfydata template now uses new dependency mergedeep to merge user conf…
Pull Request -
State: closed - Opened by knutfrode about 2 years ago
#103 - Dev
Pull Request -
State: closed - Opened by knutfrode about 2 years ago
- 1 comment
#102 - sfy-data & sfy-dashboard: move to separate repository
Issue -
State: open - Opened by gauteh about 2 years ago
- 1 comment
#101 - Dashboard crashes if OMB buoy has sent only a single imu package
Issue -
State: open - Opened by gauteh about 2 years ago
#100 - Allowing trajectory netCDF file to be subsettet in time before creation
Pull Request -
State: closed - Opened by knutfrode about 2 years ago
#99 - collection: wip
Pull Request -
State: closed - Opened by knutfrode about 2 years ago
- 3 comments
#98 - collection: wip
Pull Request -
State: closed - Opened by gauteh about 2 years ago
#97 - raw: capture raw samples
Pull Request -
State: closed - Opened by gauteh about 2 years ago
#96 - storage: store full raw data at 208 Hz or higher
Issue -
State: closed - Opened by gauteh over 2 years ago
#95 - wip: fix monitor command
Pull Request -
State: closed - Opened by gauteh over 2 years ago
#94 - Use SIMD for FIR convolution
Pull Request -
State: closed - Opened by gauteh over 2 years ago
- 1 comment
#93 - Safer litihium batteries: Li/FeS2 ?
Issue -
State: open - Opened by gauteh over 2 years ago
- 1 comment
#92 - sfy-drifter: sometimes goes crazy and sends thousands of messages
Issue -
State: closed - Opened by gauteh over 2 years ago
- 1 comment
#91 - sfy-processing: fix monitoring command
Issue -
State: closed - Opened by gauteh over 2 years ago
#90 - sfydata: OMB data: pushed from rockblock (rather than scraped)
Issue -
State: closed - Opened by gauteh over 2 years ago
- 1 comment
#89 - sfydata: export data from OMB buoys as well
Issue -
State: closed - Opened by gauteh over 2 years ago
#88 - PCB-fixes for v0.4
Issue -
State: closed - Opened by gauteh over 2 years ago
#87 - storage: re-try to initialize SD-card if it fails on start-up (fix #85)
Pull Request -
State: closed - Opened by gauteh over 2 years ago
#86 - PCB-fixes for v0.3
Issue -
State: closed - Opened by gauteh over 2 years ago
- 15 comments
#85 - storage: try to re-initialize if fails on start-up
Issue -
State: closed - Opened by gauteh over 2 years ago
#84 - Possible deadlock: panic-loop or critical-section deadlock
Issue -
State: closed - Opened by gauteh over 2 years ago
#83 - Migrate dashboard to regular React
Pull Request -
State: closed - Opened by gauteh over 2 years ago
- 1 comment
#82 - GPS: use in continuous mode for beach experiments
Issue -
State: closed - Opened by gauteh over 2 years ago
#81 - Add a pure ocean drifter
Pull Request -
State: closed - Opened by gauteh over 2 years ago
#80 - separate message_type for sfy + create indexes
Pull Request -
State: closed - Opened by gauteh over 2 years ago
#79 - NAK / SwError / ARB with IMU: add pullups to SDA / SCL
Issue -
State: closed - Opened by gauteh over 2 years ago
- 7 comments
#78 - storage v2
Pull Request -
State: closed - Opened by gauteh over 2 years ago