bdring/midtbot_esp32 issues and pull requests

#29 - Problems with hr4988 stepper drivers

Issue - State: closed - Opened by J-Wrobel over 2 years ago

#28 - Shorter mounting screws required for specified stepper motors

Issue - State: open - Opened by graumannteague over 3 years ago

#27 - Limit switches

Issue - State: open - Opened by dunkfordyce almost 4 years ago - 4 comments

#26 - No Pen Lift in Z0 .. Z5 range

Issue - State: open - Opened by scruss about 4 years ago - 14 comments

#25 - Servo setup instructions inconsistent

Issue - State: open - Opened by scruss about 4 years ago

#24 - File types and software are suitable

Issue - State: closed - Opened by admin-kepo over 4 years ago

#23 - Missing stepper motor drivers from BOM

Issue - State: open - Opened by ejo4041 over 4 years ago

#22 - sdcard

Issue - State: closed - Opened by vascobarbosa over 4 years ago - 5 comments

#21 - GrabCAD interactive model not working

Issue - State: open - Opened by mahtDFR over 4 years ago - 3 comments

#20 - Update StepperOnline link

Pull Request - State: closed - Opened by chardane over 4 years ago - 1 comment

#19 - How to setup bluetooth?

Issue - State: closed - Opened by BigDave365 over 4 years ago - 3 comments

#18 - plot file(s) with push button(s) ?

Issue - State: open - Opened by snug11 about 5 years ago - 2 comments

#17 - New Controller Revision

Issue - State: open - Opened by bdring about 5 years ago - 1 comment

#16 - Suggestion - heavier set-screw pen

Issue - State: open - Opened by dirkx about 5 years ago - 1 comment

#15 - Unstable Y axis

Issue - State: open - Opened by Kartoffel about 5 years ago - 2 comments

#14 - No ESP32 chip listed in the BOM

Issue - State: closed - Opened by dwightmulcahy about 5 years ago - 5 comments

#13 - Pen is lowered onto the paper after homing

Issue - State: open - Opened by Kartoffel about 5 years ago - 6 comments

#12 - Alternative to the 5V DC-DC Power Supply

Issue - State: open - Opened by bdring about 5 years ago - 5 comments

#11 - midTbot Controller Kits on Tindie

Issue - State: open - Opened by bdring about 5 years ago

#10 - Update BOM / ease procuring of stepper motors

Issue - State: closed - Opened by dirkx about 5 years ago - 2 comments

#9 - patch - some minor instruction updates

Issue - State: open - Opened by dirkx about 5 years ago - 1 comment

#8 - Improvement request: screw terminal

Issue - State: closed - Opened by dirkx about 5 years ago - 5 comments

#7 - Improvement request: labeling of DC/DC pins

Issue - State: closed - Opened by dirkx about 5 years ago - 3 comments

#6 - Feature/improvement: through the hole capacitors