GitHub / bartei/rotary-controller-python issues and pull requests
#37 - Feature: Jog bar servo control
Pull Request -
State: closed - Opened by gregkopp 7 months ago
- 1 comment
#36 - Fix titles of Servo and Setup screens
Pull Request -
State: open - Opened by gregkopp 7 months ago
#35 - Add an approaching ZERO tone or beeps
Issue -
State: open - Opened by gregkopp 7 months ago
#34 - Audible maximum speed warning
Issue -
State: open - Opened by gregkopp 7 months ago
#33 - Check for nmcli in network screen
Pull Request -
State: open - Opened by gregkopp 7 months ago
#31 - Changes to preferences/formats screen
Pull Request -
State: open - Opened by gregkopp 8 months ago
#30 - Toggle scale of feed rate
Pull Request -
State: open - Opened by gregkopp 8 months ago
#29 - Enable cursor unless running on the raspberry pi
Pull Request -
State: open - Opened by gregkopp 8 months ago
#27 - Hide scale when label is blank
Pull Request -
State: closed - Opened by gregkopp 8 months ago
#17 - Finish the origins management (ABS/INC) and perhaps add more origins that can be used in the system
Issue -
State: open - Opened by bartei over 1 year ago
#16 - Finish the networking configuration page and display it only when code is running on the OSPI operating system
Issue -
State: open - Opened by bartei over 1 year ago
#15 - Add keke tracing to cwd/trace.out with ctrl-t
Pull Request -
State: closed - Opened by thatch almost 2 years ago
#14 - glitch: zeroing or touching off is considered motion
Issue -
State: closed - Opened by thatch almost 2 years ago
- 4 comments
Labels: question
#13 - scale ratio defaults
Issue -
State: closed - Opened by thatch almost 2 years ago
- 2 comments
#12 - feature request: baudrate in config.ini
Issue -
State: closed - Opened by thatch almost 2 years ago
- 1 comment
#11 - feature request for components/keypad: accept keyboard input
Issue -
State: closed - Opened by thatch almost 2 years ago
- 1 comment
#10 - Exception when choosing ratio and hitting ok
Issue -
State: closed - Opened by thatch almost 2 years ago
- 1 comment
#9 - Make sure the UI can fill the screen
Issue -
State: closed - Opened by thatch almost 2 years ago
- 5 comments
#8 - Support for basic math (Z +/- quill dro)
Issue -
State: open - Opened by thatch almost 2 years ago
#7 - Per-axis disabling without editing source
Issue -
State: open - Opened by thatch almost 2 years ago
#6 - sync: thread pitch selector instead of ratio
Issue -
State: open - Opened by thatch almost 2 years ago
#5 - Communication with VFD over RS485
Issue -
State: open - Opened by bartei almost 2 years ago
#4 - Finish Tool Offsets Table
Issue -
State: closed - Opened by bartei almost 2 years ago