arduino/ArduinoCore-samd issues and pull requests

#710 - Debug enhancements

Pull Request - State: open - Opened by umbynos about 2 years ago - 3 comments
Labels: improvement, Component: Core

#496 - dpinst-amd64.exe is not signed for Windows 10

Issue - State: open - Opened by don almost 6 years ago - 14 comments
Labels: improvement

#439 - Implement SERCOM/Wire I2C timeout detection

Pull Request - State: open - Opened by jrowberg over 6 years ago - 11 comments
Labels: improvement

#208 - Cannot set UART to 300 baud

Issue - State: open - Opened by keestux almost 9 years ago - 3 comments
Labels: improvement

#98 - Use TX buffer for Wire slave writes

Pull Request - State: closed - Opened by sandeepmistry almost 10 years ago - 1 comment
Labels: improvement, Component: Wire

#97 - Added externs for additional Wire instances

Pull Request - State: closed - Opened by spiderkeys almost 10 years ago - 5 comments
Labels: improvement, Component: Wire

#96 - Clear RX buffer in TwoWire::requestFrom before reading

Pull Request - State: closed - Opened by sandeepmistry almost 10 years ago - 1 comment
Labels: improvement, Component: Wire

#95 - Correct use of I2C slave address mask

Pull Request - State: closed - Opened by sandeepmistry almost 10 years ago
Labels: improvement, Component: Wire

#92 - [USB CDC] Only re-enable IRQ if PRIMASK was 0 before disabling IRQ

Pull Request - State: closed - Opened by sandeepmistry almost 10 years ago - 2 comments
Labels: improvement, Component: USB-CDC

#88 - Fix 10 second blocking delay

Pull Request - State: closed - Opened by bbx10 almost 10 years ago - 2 comments
Labels: improvement, Component: USBHost

#86 - Use asynchronous fractional mode to configure UART

Pull Request - State: closed - Opened by sandeepmistry almost 10 years ago
Labels: improvement, Component: HardwareSerial

#82 - Behaviour of Uart::flush() differs from AVR

Issue - State: closed - Opened by TomKeddie almost 10 years ago
Labels: bug, improvement, Component: HardwareSerial, Component: Core

#81 - Fix async serial port operation at 1200 baud, fix flush, fix data bits.

Pull Request - State: closed - Opened by TomKeddie almost 10 years ago - 5 comments
Labels: improvement, Component: HardwareSerial

#78 - add support for I2C repeated start, tested with MB85RC256V

Pull Request - State: closed - Opened by ladyada almost 10 years ago - 5 comments
Labels: improvement, Component: Wire

#74 - Adding more available ADC channels for SAMD21J18

Pull Request - State: closed - Opened by aethaniel almost 10 years ago
Labels: improvement, Component: Core

#72 - [bl] Allowing USB VID customization

Pull Request - State: closed - Opened by aethaniel almost 10 years ago - 4 comments
Labels: improvement

#70 - Warning in USBCore.cpp:649:8

Issue - State: closed - Opened by unbiot almost 10 years ago - 1 comment
Labels: improvement

#68 - Fix a warning with the SmartEverything board

Pull Request - State: closed - Opened by unbiot about 10 years ago - 2 comments
Labels: improvement

#67 - Port Stream parseInt and parseFloat enhancements

Pull Request - State: closed - Opened by sandeepmistry about 10 years ago
Labels: improvement, Component: Core

#65 - Port some AVR Serial_ (SerialUSB) API's over

Pull Request - State: closed - Opened by sandeepmistry about 10 years ago - 17 comments
Labels: improvement, Component: USB-CDC

#64 - [bootloader] [test needed] Bootloader leds activity

Pull Request - State: closed - Opened by aethaniel about 10 years ago - 7 comments
Labels: improvement, Component: Bootloader

#63 - Send a ZLP if data size is multiple of EPX_SIZE for USB sends

Pull Request - State: closed - Opened by sandeepmistry about 10 years ago - 1 comment
Labels: improvement, Component: USB-CDC

#59 - Add SPI.transfer16(...) API's

Pull Request - State: closed - Opened by sandeepmistry about 10 years ago
Labels: improvement, Component: SPI

#58 - Add TX buffer for Serial

Pull Request - State: closed - Opened by sandeepmistry about 10 years ago - 3 comments
Labels: improvement, Component: HardwareSerial

#47 - Bootloader rework

Pull Request - State: closed - Opened by aethaniel about 10 years ago - 1 comment
Labels: improvement, Component: Bootloader

#46 - Wire Slave

Pull Request - State: closed - Opened by sandeepmistry about 10 years ago - 2 comments
Labels: improvement, Component: Wire

#44 - Bootloader as Atmel Studio Project

Issue - State: closed - Opened by AloyseTech about 10 years ago - 2 comments
Labels: improvement, Component: Bootloader

#37 - SMBus Support

Issue - State: closed - Opened by Proclivis over 10 years ago - 4 comments
Labels: improvement, Component: Wire

#34 - analog write frequency too high

Issue - State: closed - Opened by Makeblock-official over 10 years ago - 1 comment
Labels: improvement, Component: Core

#33 - Serial is not buffered

Issue - State: closed - Opened by cmaglie over 10 years ago
Labels: improvement, Component: HardwareSerial

#29 - Implement Wire.end() for SAMD core

Pull Request - State: closed - Opened by sandeepmistry over 10 years ago
Labels: improvement, Component: Wire

#27 - USB Device improvements and stability fixes

Pull Request - State: closed - Opened by cmaglie over 10 years ago - 3 comments
Labels: bug, improvement, Component: USB Device

#26 - Relax digitalWrite parameter check

Pull Request - State: closed - Opened by facchinm over 10 years ago - 6 comments
Labels: improvement, Component: Core

#21 - Added function setClock on bus I2C

Pull Request - State: closed - Opened by PaoloP74 over 10 years ago - 2 comments
Labels: improvement, Component: Wire

#20 - [PATCH] Wire library: coding unnecessarily complex

Issue - State: closed - Opened by hfvogt over 10 years ago - 2 comments
Labels: improvement, Component: Wire

#19 - Enable C11/C++11

Pull Request - State: closed - Opened by cmaglie over 10 years ago - 1 comment
Labels: improvement

#17 - Bundle samd only windows drivers

Issue - State: closed - Opened by ffissore over 10 years ago
Labels: improvement

#16 - Add Wire.setClock dummy function

Pull Request - State: closed - Opened by PaoloP74 over 10 years ago - 1 comment
Labels: improvement

#14 - Wire.setClock() on Arduino Zero

Issue - State: closed - Opened by PaoloP74 over 10 years ago - 1 comment
Labels: improvement, Component: Wire

#11 - Arduino Zero <avr/sleep.h>

Issue - State: closed - Opened by ffissore over 10 years ago - 4 comments
Labels: improvement, Component: AVR compat

#8 - Enabling PWM on pins A1/A2

Pull Request - State: closed - Opened by cmaglie over 10 years ago - 2 comments
Labels: improvement

#7 - burning the SAM-BA bootloader with an external programmer (e.g. Atmel-ICE) [Zero]

Issue - State: closed - Opened by BlackBrix over 10 years ago - 1 comment
Labels: improvement, Component: Uploader

#6 - RX/TX led not blinking in USB-CDC

Issue - State: closed - Opened by cmaglie over 10 years ago - 6 comments
Labels: improvement, Component: Bootloader, Component: USB-CDC

#5 - Fix properties for USBHost library

Issue - State: closed - Opened by cmaglie over 10 years ago
Labels: improvement, Component: USBHost

#4 - add rtos systick entrance

Pull Request - State: closed - Opened by Makeblock-official over 10 years ago - 2 comments
Labels: improvement

#3 - spi on other pin

Issue - State: closed - Opened by bobricius over 10 years ago - 12 comments
Labels: improvement, Component: SPI

#2 - .... Reset not supported for this CPU.

Issue - State: closed - Opened by bobricius over 10 years ago - 6 comments
Labels: improvement, Component: Uploader

#1 - bootloader - TX led not blink when uploading

Issue - State: closed - Opened by bobricius over 10 years ago - 4 comments
Labels: bug, improvement, Component: Bootloader

GitHub / arduino/ArduinoCore-samd issues and pull requests